Electronics > Beginners
Circuit resetting when touching one multimeter probe to GND
<< < (3/3)
KaneTW:
To clarify, it's not just GND (that's just what I thought at first). Touching *any* pin triggers the reset (analog input, digital input, etc).
KaneTW:
Measured it at the ADC's DVDD. This was triggered by touching GND with an inductance (multimeter probe, sufficiently long wire, etc). Anything I can do about it?
joeqsmith:
Welcome to the wonderful world of compliance testing. 
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod