Electronics > Beginners

Circuit resetting when touching one multimeter probe to GND

<< < (3/3)

KaneTW:
To clarify, it's not just GND (that's just what I thought at first). Touching *any* pin triggers the reset (analog input, digital input, etc).

KaneTW:
Measured it at the ADC's DVDD. This was triggered by touching GND with an inductance (multimeter probe, sufficiently long wire, etc). Anything I can do about it?

joeqsmith:
Welcome to the wonderful world of compliance testing. 

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod