Electronics > Beginners
What could be this component
(1/2) > >>
TestSubjectZero:
Hi guys,

This is far fetch but I'm trying to identify what could be a component which fried.
It not possible to read the making on the component. However, I can explain the setup. It sits between a the drain of the FDD4141 mosfet and the positive connection of a electronic speed controller.
The circuit is feed 24v.

Any ideas?

Thanks
rsjsouza:
It is a SMD diode, but I can't read the marking very well.
TestSubjectZero:
I've tried read the making under a microscope but read there is nothing to be recovered.

A small additional information, I've simply connected the mosfet drain to the positive pin of the ESC and everything works.

So what type of diode could it be?
ataradov:
Given that there is a motor connector nearby, this is a flyback protection diode. I would not run for too long without replacing it.

Find something beefy enough in this package, it should not matter all that much.
TestSubjectZero:

--- Quote from: ataradov on October 12, 2018, 10:09:22 pm ---Given that there is a motor connector nearby, this is a flyback protection diode. I would not run for too long without replacing it.

Find something beefy enough in this package, it should not matter all that much.

--- End quote ---

It doesn't seem to be connected in parallel to the ESC power pins, could it be something else?
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod