Electronics > Beginners

What could be this component

(1/2) > >>

TestSubjectZero:
Hi guys,

This is far fetch but I'm trying to identify what could be a component which fried.
It not possible to read the making on the component. However, I can explain the setup. It sits between a the drain of the FDD4141 mosfet and the positive connection of a electronic speed controller.
The circuit is feed 24v.

Any ideas?

Thanks

rsjsouza:
It is a SMD diode, but I can't read the marking very well.

TestSubjectZero:
I've tried read the making under a microscope but read there is nothing to be recovered.

A small additional information, I've simply connected the mosfet drain to the positive pin of the ESC and everything works.

So what type of diode could it be?

ataradov:
Given that there is a motor connector nearby, this is a flyback protection diode. I would not run for too long without replacing it.

Find something beefy enough in this package, it should not matter all that much.

TestSubjectZero:

--- Quote from: ataradov on October 12, 2018, 10:09:22 pm ---Given that there is a motor connector nearby, this is a flyback protection diode. I would not run for too long without replacing it.

Find something beefy enough in this package, it should not matter all that much.

--- End quote ---

It doesn't seem to be connected in parallel to the ESC power pins, could it be something else?

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod