| Electronics > Beginners |
| What Kind of Silicone Coating is This? |
| (1/1) |
| KDoug:
Hi, brand new to this forum. I'll just state up front that I have limited knowledge on electronics but am willing to learn so I can repair my own stuff. I have a Dewalt DCS355 oscillating tool (power tool that cuts various materials through vibration) that I have made a repair. I had to take the circuit board out to make the repair and to do that I had to remove a lot of this "potting" type silicone that covered the board. I've looked around a good bit but most of the potting compounds I've seen online aren't silicone. The ones I have seen are usually a two part mixture and I'm not sure if that's what I need or not. Can y'all point me in the right direction of what I need. Attached are some photos. Thanks |
| KDoug:
It says I can't post pictures larger than 1000kb, how do I get around this? |
| robjodicarter:
It's a waterproof coating, as long as you use a waterproof dielectric coating your good man. Sent from my PH-1 using Tapatalk |
| KDoug:
I have some MG Chemicals silicone conformal coating I just bought. The board was pretty much water proof, not sure why though. The tool makes a lot of vibration so I assumed it needed a lot of this coating to dampen it. I'm not just looking to spend money, so if you don't think I need it I'm ok with just using the conformal coating. I just want to repair it right. |
| Navigation |
| Message Index |