Electronics > Beginners
What probes / leads will I need for this Siglent meter, power supply, and scope?
tautech:
--- Quote from: klausES on February 19, 2020, 12:04:02 am ---
--- Quote from: tautech on February 18, 2020, 01:47:03 am ---Found the leads as an accessory on the US site:
https://siglentna.com/product/multimeter-probes/
Not sure if they come with the slip on croc clips or not but I guess they would. :-//
--- End quote ---
The image on the Siglent link page is out of focus.
It could be older ?!?
The ones on my SDM3055 (in December) look slightly different and there were also alligator clips (spring-loaded 2mm Lab Standard) for the tips.
--- End quote ---
Yes it's possibly an old image and yes alligator clips and probe tip condoms have been standard fare for a while.
I'll check with the factory if the SDM-PB replacement probes come with those accessories too.
--- Quote ---On some Siglent sites, firmware from 2016/2017 is still listed as current for many devices ...) ::)
--- End quote ---
Some owners still have never updated their firmware ::) and there's important freeze recovery updates and some that need be done in stages/steps on order to get to the latest version so it's necessary these old FW updates remain accessible. It's all listed in the FW Release notes. ;)
tautech:
Word for word reply from Siglent:
Yes, the new SDM test leads Pt # SDM-PB replacement probes have been supplied with clips and the probe pin sleeve since last year.
klausES:
Yes, that must be exactly the same as from my new SDM3055 and the one I meant. :D
Navigation
[0] Message Index
[*] Previous page
Go to full version