| Electronics > Beginners |
| which parts for wiring a 4pin connector |
| (1/2) > >> |
| LaserTazerPhaser:
Does this need ferrules or something else? https://www.digikey.com/product-detail/en/1-480703-0/A1453-ND/29345/?itemSeq=291952439 Perhaps Digikey carries the appropriate parts for this specific connector I haven't done much connectors not sure which is correct method to get this working. |
| MarkF:
The mating connector and associated contact pins/sockets are shown at the bottom of the Digikey page you linked to. You will also need a crimping tool. |
| oliver602:
Here is a selection chart for the different TE Mate-N-Lok contacts and housings. |
| LaserTazerPhaser:
Going to obtain these https://www.digikey.com/product-detail/en/350547-1/A14300-ND/213765/?itemSeq=292610804 how do they plate the inside with 2 separate metals without plating the outside with the same metals? |
| oPossum:
Probably plated before stamping. |
| Navigation |
| Message Index |
| Next page |