Electronics > Beginners

which parts for wiring a 4pin connector

(1/2) > >>

LaserTazerPhaser:
Does this need ferrules or something else?
https://www.digikey.com/product-detail/en/1-480703-0/A1453-ND/29345/?itemSeq=291952439

Perhaps Digikey carries the appropriate parts for this specific connector I haven't done much connectors not sure which is correct method to get this working.

MarkF:
The mating connector and associated contact pins/sockets are shown at the bottom of the Digikey page you linked to.
You will also need a crimping tool.

oliver602:
Here is a selection chart for the different TE Mate-N-Lok contacts and housings.

LaserTazerPhaser:
Going to obtain these https://www.digikey.com/product-detail/en/350547-1/A14300-ND/213765/?itemSeq=292610804 how do they plate the inside with 2 separate metals without plating the outside with the same metals?

oPossum:
Probably plated before stamping.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod