Electronics > Beginners
Why can't I see bouncing of switch on oscilloscope screen?
<< < (3/3)
StillTrying:

--- Quote from: vk6zgo on April 06, 2019, 01:00:12 pm ---Surely there must be a way to do this with a modern DSO.
--- End quote ---

Yes it's dead easy.
Resistor about 1K to 10K.
X speed about 5ms/div.
With the trigger on AUTO set the trigger LEVEL mid-way between the high and low trace levels of the signal, then switch the trigger to NORMAL. Every switch change will show a capture, if it's bouncing.



--- Quote from: vk6zgo on April 06, 2019, 01:00:12 pm ---Wouldn't "roll" do this on a DSO----it seems to have no other use!

--- End quote ---

I think it's very useful for slow changing signals, you get to choose when to press STOP by eye.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod