Electronics > Beginners
Why won't my meters read millivolts?
<< < (3/3)
billbyrd1945:
Thank you very much. This has been a good learning experience for this 73y/o.
Mechatrommer:
OL = Over Load.. did i just do that?  or its already there?
Nusa:

--- Quote from: Mechatrommer on October 16, 2018, 11:52:16 pm ---OL = Over Load.. did i just do that?  or its already there?

--- End quote ---

It's in the manual I linked. OL = "The input value is too large for the selected range."
billbyrd1945:
"It's in the manual I linked. OL = "The input value is too large for the selected range."
Thanks once again! I always thought OL meant open line.
Mechatrommer:
yes that is resistance mode. whatever it is as long as it helps our mental picture.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod