Electronics > Beginners

Why won't my meters read millivolts?

<< < (3/3)

billbyrd1945:
Thank you very much. This has been a good learning experience for this 73y/o.

Mechatrommer:
OL = Over Load.. did i just do that?  or its already there?

Nusa:

--- Quote from: Mechatrommer on October 16, 2018, 11:52:16 pm ---OL = Over Load.. did i just do that?  or its already there?

--- End quote ---

It's in the manual I linked. OL = "The input value is too large for the selected range."

billbyrd1945:
"It's in the manual I linked. OL = "The input value is too large for the selected range."
Thanks once again! I always thought OL meant open line.

Mechatrommer:
yes that is resistance mode. whatever it is as long as it helps our mental picture.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod