Will this relay work for my requirements?

[redgear]

I am trying to drive a 6A reactive load(power factor 0.6, crest factor 1.85) using a DC relay. Either 12v or 5v.
I found this relay on digikey: DATASHEET
Will this suit my requirements?

Thanks

[bob91343]

I don't see any reactive load specifications.  So it's a crap shoot.  Best to contact the relay manufacturer and ask.

[cliffyk]

It's rated at 20 A for use with a 277 VAC lighting ballast--should be fine for your application:

[floobydust]

OP is being a jerk, his 8-page cross-posted thread https://forum.allaboutcircuits.com/threads/critique-my-schematic.171272/page-8 he says he needs a 4-pole relay 

[redgear]

It's rated at 20 A for use with a 277 VAC lighting ballast--should be fine for your application:

I don't see any reactive load specifications.  So it's a crap shoot.  Best to contact the relay manufacturer and ask.

Thanks.

OP is being a jerk, his 8-page cross-posted thread https://forum.allaboutcircuits.com/threads/critique-my-schematic.171272/page-8 he says he needs a 4-pole relay 

I am looking for replacing the 4-pole relay as they are very expensive

[cliffyk]

Lighting ballasts are commonly reactive loads. Even those in the fluorescent lights in your garage...