Electronics > Beginners
x86 industrial motherboard with unknown connector
(1/2) > >>
crazy_driver:
Hi, i have this motherboard on my wheel balancer. SECCO Italy CS478 REVB
Geode 200mhz 8Mb sdram


All i can find in google is that it is a DIN 41612.

https://www.conrad.com/p/assmann-wsw-a-cf96abct-spring-pin-design-c-straight-number-of-pins-96-a-b-c-742287

I am afraid that the motherboard will die again (already did twice)
Is it possible to adapt this pinout to a isa or pci to use on a more modern motherboard?

https://www.amd.com/system/files/TechDocs/5530a_db.pdf
amyk:
Figure out why it's dying first...
Per Hansson:
https://en.wikipedia.org/wiki/DIN_41612

Often used in what is called the European industrial connector.
Many times it is just a standard PC/104 interface in a special connector.
For being mounted in a 19" rack...
crazy_driver:
it died because of memory, i think the onbord 8Mb are not ok so the first time i used a 32mb dimm and it worked for a little bit.
After that i even tryed to reflow the grafic chip but for nothing, i found another 64mb dimm and it works again.

i saw many boards with the 104 conector it would be a lot better to find than this.
amyk:

--- Quote from: crazy_driver on July 29, 2019, 08:48:50 am ---it died because of memory, i think the onbord 8Mb are not ok so the first time i used a 32mb dimm and it worked for a little bit.
After that i even tryed to reflow the grafic chip but for nothing, i found another 64mb dimm and it works again.

i saw many boards with the 104 conector it would be a lot better to find than this.

--- End quote ---
Check the caps and especially the stability of the RAM supply voltage. They don't just die for no reason.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod