Electronics > Beginners
Your best/worst innovative but completely incorrect usage of tools...
G0HZU:
I've used my Tek RSA3408A 8GHz real time spectrum analyser as a battery charger via the USB port a few times.
http://www.testequipmenthq.com/datasheets/TEKTRONIX-RSA3408A-Datasheet.pdf
I think you can buy cheaper and smaller battery chargers than the Tek but it does seem to work very well :)
malagas_on_fire:
I use a pole testing neither to screw or test the poles on mains, but it can be used to pry some boxes, test the battery mosquito zapper if is discharged after use or to block something to get loose, like a door.
GeorgeOfTheJungle:
I like to peel the wires with my teeth.
GeorgeOfTheJungle:
--- Quote from: capt bullshot on October 12, 2018, 07:47:13 pm ---Often enough, I've used a flat blade screwdriver to drill holes in plastic enclosures.
--- End quote ---
The tip of the iron is good for that too :-)
Kleinstein:
I quite regularly use Torx bits for imperial size Allan key screws - works reasonably.
I never tries this:
https://www.dell.com/community/Desktops-General-Read-Only/I-need-help-with-my-cupholder/td-p/784435
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version