EEVblog Electronics Community Forum

EEVblog => EEVblog Specific => Topic started by: Lawsen on September 11, 2011, 07:55:12 pm

Title: EEV Blog: 194; "Lab Bench Build"
Post by: Lawsen on September 11, 2011, 07:55:12 pm
Supporting the end of the new table top addition is difficult, because there needs to be room for the car.  This left hand side corner will be a cantilever support.  It can use a low angle, long right angle brace underneath the table top at the table legs.  The car's hood must fit in with the brace without touching or scratching the car's front hood, bonnet.   I have thought about a steel cable suspension for the table top, but not as attractive appearance, a suspension table top like a suspension bridge. 

I am trying to figure out how to add an extra table top in my small bedroom for my instruments and things.