EEVblog > EEVblog Specific

EEVblog 1431 - Keysight EDU33212A Function Generator Teardown

(1/2) > >>

EEVblog:
Teardown of the new Keysight  EDU33212A 20MHz Function Generator

Odysee exclusive: https://odysee.com/@eevblog:7/Photo-Spectrometer-Teardown:7


Anthocyanina:
"FUNC_30M_V1.04"
Hmmm, that "30M" makes me wonder, are they thinking of releasing a 30Mhz software upgrade at some point?

TheSteve:
Sure seems they had 30 MHz in mind doesn't it.

Maybe Dave can hack it.

radioing:
Hi, to parallelize CFAs in arb. generators is well known technique for years. The reason is to distribute power dissipation over more chips and to decrease the output current per chip which makes better THD, especially at upper part of frequency band and high voltage amplitude. What surprises me is that only two CFAs are used per channel. I remember Agilent or R&S arb. gen. where the same four CFAs were used in parallel and even they were with heatsinks, the temperature @20 MHz/10Vpp/50ohms load was really high. Maybe, that's the reason the '30M' label downs to 20 MHz in reality (together with THD worsening at higher freqs).

Boscoe:
Nice video, Dave. I've always loved the tear downs.

Dave, I wonder if you could do a video on length matching. It's something I don't really understand as a few mm difference in length would only offer a difference in time of femto seconds assuming 1/3rd the speed of light. Nothing to really worry about.

It's interesting they went with Cyclone 10 + STM32 on this design. I assume it's because they could source the Zynqs at the mo?

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version