EEVblog > EEVblog Specific

EEVblog 1616 - Weller Zero Smog Fume Extractor Review

(1/2) > >>

EEVblog:
How much does the Weller HEPA 13 Zero Smog EL Kit fume extractor suck?
https://www.weller-tools.com/eu/gb/filtration/products/solder-fumes/zero-smog-el-kit-1

aeberbach:
If you compress your hose it's not as floppy.
Also I needed to put mine under a shelf so there is less overhead clearance and the minimum bend of the hose is too large, 3D printed a 90 degree adapter for the duct.

Kleinstein:
For getting it quieter, the natural thing would be some "filter" / sound absorber at the output side of the fan.

This is quite an expensive filter !  Depening on the climate (high humidity) one may have to change the filter after some time, even if not heavily used.

EEVblog:
And that external RJ11 interface is only an on/off switch.

https://www.mouser.com/ProductDetail/Weller/FT91000033?qs=QvRObDHRS1%252BRKK8h4zvMOA%3D%3D

EEVblog:
Part 2

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod