EEVblog > EEVblog Specific
EEVblog #576 - Advantest R6142 Current Voltage Generator
lern01:
--- Quote from: taichi on March 03, 2024, 12:42:45 am ---Have you tried resetting the calibration data? Procedure is written in operation manual. Turn the ext cal switch on the rear panel on, and power on, then press 0.
I once had this problem and resolved by this procedure even though I forgot the exact error code.
--- End quote ---
Thank you very much for your advice, I reprogrammed the AT59C11 with Superpro 500P and it fixed the problem perfectly. thank you!
Navigation
[0] Message Index
[*] Previous page
Go to full version