EEVblog > EEVblog Specific

EEVblog #978 - Keysight 1000X Hacking

<< < (191/196) > >>

Bud:
I do not know.

pa3hfu:
Hi there,
Today I updated my 1000X with the BUD file. See photo 1
All licenses are active now, but the bandwidth remains 50Mhz.
Am I missing something?
Thanks in advance!
Mathieu

Anthocyanina:

--- Quote from: pa3hfu on February 24, 2023, 04:50:42 pm ---Hi there,
Today I updated my 1000X with the BUD file. See photo 1
All licenses are active now, but the bandwidth remains 50Mhz.
Am I missing something?
Thanks in advance!
Mathieu

--- End quote ---
Hi, you can see it also says BW20, which is the 200MHz option, i believe. have you checked the timebase? with that firmware it should get to 2ns/, which is only available when unlocked to 200MHz if i'm not wrong. I may be remembering wrong, but i think there were some components that needed to be added or removed from the edu version to fully unlock the hardware to 200MHz, but that doesn't change what the software unlock does.

Bud:
This option requires hardware upgrade in the front end channels. Information is in this thread.

pa3hfu:
Ok. I thought that hardware-mod was not necessary anymore.
When I load the Fercsa hack, the bandwidth becomes 70 Mhz!
Timebase = 5ns

Navigation

[0] Message Index

[#] Next page

[*] Previous page