EEVblog Live Soldering Haasoscope

[Quarlo Klobrigney]

Here's about all I can do in 1 hour. I do have a life after all. I use have used Eagle since 3.xx and will until I can master Kicad.
Here is a partial redraw of the mess. Please look at some YouTube videos for the proper way to draw a schematic.
you can see the start of a bus being drawn (blue line). i don't want to go further.
It should give a clue as to how long (using Eagle) to redraw it.

Dave... Eagle is not hard to master IF: you don't try to use it as Altium.
The Eagle GUI is all I use, dumbed down to a ver 3.xx view.

And now a preview of our main attraction:
Yes it is an open sore not a source.

[haastyle]

I made an attempt at cleaning up my schematic. Comments welcome!

https://github.com/drandyhaas/Haasoscope/blob/master/eagle/max10adc_v9.0_schematic.pdf

[Quarlo Klobrigney]

Please turn off pins in the layers and print again. I would have like to have seen Busses and not separate blocks with wires that just end in free air. PIN_ANALOG_IOEXP connector and others, have junction dots on the pins. This means that you have loose unconnected wires.

Anyway, I guess you have time to redo it.

Quote from: haastyle on Today at 14:36:27

I made an attempt at cleaning up my schematic. Comments welcome!

>https://github.com/drandyhaas/Haasoscope/blob/master/eagle/max10adc_v9.0_schematic.pdf

[haastyle]

Thanks!
What do you mean by "turn off pins in the layers"?
Those junction dots were superfluous and harmless; I just removed them.