EEVblog > EEVblog Specific

The Dark Side of the Rigol Hack -- Bricked Scope & How to Fix it...

<< < (37/37)

uoemx:
Hi everyone I want to help everyone on this topic.
I would remove the flash memory and do a full flash backup using an RT809H or TL899, or similar on my machine in normal use
You load into your Rigol DS1052E, the machine will use normally. All software version serial numbers will of course be mine.
If you agree, I will back up my device and send it to you. Thread may end and this is the final solution and 100% working

uoemx:
My machine can't adjust the trigger to make the signal stable, maybe hardware failure. Can someone tell me what to check?

Status here


here full fLASH 8Mb
https://www.mediafire.com/file/3x54qaymlws23mh/Rigol_1052E.zip/file
Firmware update 100Mhz
https://www.mediafire.com/file/0gtsusastgtheyk/Rigol_1052E_hack_100Mhz_Tested.zip/file

malamig:
Hello!
I was able to restore my 1052E from the dump file gave by UOEMX.
FW Version now is 00.04.02.01.00
However, I cannot upgrade to 100Mhz. Maybe I need to downgrade the FW to 2.04.
I tried both thru Serial command and USB FW but no luck.

Anyway, for now I will just keep my scope running on 50Mhz. Thank you UOEMX!

uoemx:
No problem malamig.  I have finished fixing my oscilloscope.  I have shared the diagram and the broken part, everyone can see the reference.  The diagram is here: http://rigol.codenaschen.de/index.php/Schematics. 
Here's where I did it

prieten:
Hello, my RIGOL DS1064B oscilloscope is not working properly after the update. Does anyone have the firmware in the Flah memory S29GL064N90TFI04 for hardware version DB 4.3. I mention that after the update the USB ports are no longer functional, the only solution is to rewrite the flah memory.  Thank you in advance.

Navigation

[0] Message Index

[*] Previous page