EEVblog Electronics Community Forum
General => Buy/Sell/Wanted => Topic started by: tnt on April 17, 2011, 09:07:50 pm
-
Hi,
Does anyone here has a wire bonding machine / access to one and would be willing to provide service (for a fee obviously) ?
I have some BGA ICs soldered on a board that I'd like to probe, and on the 'edge' of it,there is 100 small 'gold' tabs but they're way too small to solder directly so I was thinking a wire bonding machine could be used to bring them to larger test pads ...
Cheers,
Sylvain
-
You might have better luck getting it probed for you. I'd check with a FA lab.
-
Well it's for a long term project ...
I want to experiment with the software on the chip and see the result in HW (don't have full specs/details) so I can't just go probe it once, I need it in continuous at my lab ...