EEVblog Electronics Community Forum
General => Buy/Sell/Wanted => Topic started by: nikifena on March 15, 2024, 04:13:58 pm
-
I'm selling this calibrator. It works great. All buttons work. I haven't calibrated it, but it looks pretty close to my Fluke. There are a few trimpots inside for calibration. This calibrator comes with a built-in battery pack, but I removed it in the past since the batteries were dead, and used it with an external power supply. If someone wants to use it with batteries, 6 AA Ni-MH batteries in series will do the job.
The photos show everything.
Asking 220 Euro for it without shipping.
-
Hello,
What are the output ranges about U and I ?
Br
-
Voltage range 10 μV to 11.000 V
Current range 2 μA to 22.00 mA
Here are the datasheets + calibration procedure
-
How old? After decads the LCDs all fail.
j
-
not all of them ...
-
How old? After decads the LCDs all fail.
j
Did you see any degradation to this display? If you find anything disturbing from the photos, show me, I will give you that calibrator for free ;D :-DMM
-
How old? After decads the LCDs all fail.
j
Capacitors fail too, switches and even semiconductors fail. So - what`s your point?
-
How old? After decads the LCDs all fail.
j
I suggest to FIRST look at the pictures attached and then write something.
The last picture shows a production date.
Another possible explanation is you love to troll and spam the "Buy/Sell/Wanted" section.
-
How old? After decads the LCDs all fail.
j
That's an issue of 70s LCDs, mid 80s rarely fail (in my experience).
This is from 1985. So it survived for almost 40 years, unlikely to fail in the next months, I guess.