(SOLD):EU KS 34461A 6 1/2 DMM

[Antonio90]

I'm selling a KS34461A with GPIB option installed, as I have two, and a 34401A coming. According to the serial number, it is from 2018, so 5 1/2 years old.
Last calibration is from 2021, although I performed zero calibration with a 4-wire short, after a few hours of stabilizing with the short connected.

It works perfectly AFAIK, and it has done so since August last year when I got it, however, it is a bit roughed up I'm afraid, don't know if it was dropped or hit with something at some point in it's life, but it certainly looks like it.

It has a slight crack in the front panel plastic, which I didn't see until today, taking the photos to sell it 
Also, the external metal chassis is slightly depressed in one of the sides, close to the rear. I haven't been able to find any hint of damage on the inside though.
It was used in a rack and came without bumpers/handle. I bought a set of bumpers which will be attached to help protect it during shipping.

Asking price is €600 plus shipping at cost, but I am open to offers. Also, If you want me to do any kind of test please ask. Sadly, I don't have metrology grade standards, or anything of the like.
I can post comparisons with the rest of my DMMs, though.

[Antonio90]

More photos including a closeup on the crack of the front with flash to highlight it, and a couple CSV captures (semicolon column separator and comma for decimals). These were done with banana plugs and thick wire on 2 terminals, so not ideal.

EDIT: The photo with the crack highlighted didn't upload properly. It isn't quite visible still, but it runs from the left arrow button to the bezel.

[Antonio90]

Readings from a cheap  reference, based on the AD584JH.
Don't have any precission resistors, and kelvin clips haven't arrived yet. Attached is a 4-wire measurement of a 100R 0.1%, if only for showing it works.

[Antonio90]

Photos with bumpers installed.

[Antonio90]

Sold for €550 + shipping at cost.