Wanted:Working Fluke 8842A option -09

[AB9GO]

Looking for the true RMS option board for my Fluke 8842A.  Looking for the option or a lead where to find one.

Thanks.
Randy AB9GO

[Simon]

Ebay can turn up some good bargins but general common sense for not getting burnt applies

[AB9GO]

Ebay can turn up some good bargins but general common sense for not getting burnt applies

Nothing much showing up there recently.  Oh well...

[mkissin]

I may have one of these. I can't remember if it's for the 8840 or 8842 though. I'll have to check when I get home. IIRC the two should be interchangable, but they have slightly different pinouts on the connector so you'd need to make up a wee adaptor cable.

[mkissin]

OK, I've definately have an 8840A-3009, revision M board.

Cosmetically, it's in great condition, but I honestly have no idea if it works or not. I also have schematics for this board and the one you actually want, and can tell you that they are the same except that pins 1 and 8 on the main connector have been transposed (it's a 20-way IDC header).

Send me a PM if you'd like it.

[dumpystig]

I realise this is an old topic but I'm looking for the same board. Did you get rid of yours or do you still have it?

[mkissin]

Me? I still have it. Send me a PM if you want it and we can discuss.

[dumpystig]

PM sent