General > Buy/Sell/Wanted

Wanted:Working Fluke 8842A option -09

(1/2) > >>

AB9GO:
Looking for the true RMS option board for my Fluke 8842A.  Looking for the option or a lead where to find one.

Thanks.
Randy AB9GO

Simon:
Ebay can turn up some good bargins but general common sense for not getting burnt applies

AB9GO:

--- Quote from: Simon on March 13, 2011, 08:30:38 pm ---Ebay can turn up some good bargins but general common sense for not getting burnt applies

--- End quote ---

Nothing much showing up there recently.  Oh well...

mkissin:
I may have one of these. I can't remember if it's for the 8840 or 8842 though. I'll have to check when I get home. IIRC the two should be interchangable, but they have slightly different pinouts on the connector so you'd need to make up a wee adaptor cable.

mkissin:
OK, I've definately have an 8840A-3009, revision M board.

Cosmetically, it's in great condition, but I honestly have no idea if it works or not. I also have schematics for this board and the one you actually want, and can tell you that they are the same except that pins 1 and 8 on the main connector have been transposed (it's a 20-way IDC header).

Send me a PM if you'd like it.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version