WBT: JBC T245 Stand

[Ysjoelfir]

Hi everyone,
I'm looking for a T245 Stand that gives the possibility to use the power down features.
Can be totaly dirty and even somehow damaged, at least as long it stays in one piece.
Needs to get somehow to germany.
Thanks in advice!

[on4top]

also looking for such original stand ...but new way to expensive ..

meanwhile i'm using an old weller with a wire connected :-)



works perfect :p

[Ysjoelfir]

I have the exact same stand here. Might give it a try

[on4top]

yep you really should .

found the pinouts here on the forum to make cable .. since my iron doesn't connect direcly to the station ( other connector )

[jeffaroo]

For my DIY JBC I modified a Hakko stand to take the hand piece.

[Ysjoelfir]

Java-Chai-Cafe-Foam? Sounds interesting. I like Coffee-Foam. And your Idea. What did you do to make the iron hold in there? I see some kind of metal ring?

[nanofrog]

Hi everyone,
I'm looking for a T245 Stand that gives the possibility to use the power down features.
Can be totaly dirty and even somehow damaged, at least as long it stays in one piece.
Needs to get somehow to germany.
Thanks in advice!

Found a used one here in the US and the seller will even ship to Germany (here). Shipping and handling is insane however ($184.52  ), but perhaps contacting the seller could fix this. 

also looking for such original stand ...but new way to expensive ..

meanwhile i'm using an old weller with a wire connected :-)

works perfect :p

Nice solution. 

[jc101]

I have a whole JBC CD-2BC soldering station shortly surplus to requirements, that does technically also contain a T245 stand if you really stuck - it will probably end up on here in the not too distant future.

[ilqpli]

you can buy the one in below and replace the connector to JBC one.

https://item.taobao.com/item.htm?spm=a230r.1.14.107.24a02987VSCuPa&id=546236227108&ns=1&abbucket=12#detail