General > Buy/Sell/Wanted

WTB: Cadsoft EAGLE License 4.1 and newer

(1/4) > >>

I‘ve started a new project, but my design is reaching my eagle license limits, i‘m using EAGLE 4.1 Standard, this version is limited to a maximum of 4 layers (later „Standard“ versions allow up to 6 layer) so i‘m looking for a EAGLE 4.1 Professional or EAGLE 5+ Standard or Professional license.

"new project", so use it an excuse to try kicad, eagle 4 is 15 years old ...


--- Quote from: langwadt on May 25, 2022, 10:43:51 pm ---"new project", so use it an excuse to try kicad, eagle 4 is 15 years old ...

--- End quote ---

Doesn‘t matter how old it is. I‘m experienced with it and i don‘t want to waste my time with learning a new software and recreating all librarys i‘ve created the last 15 years.

I know that Kicad reached a level which can compete with „professional“ tools but if i would want to do Kicad, i hadn‘t created this thread.

Do their original license terms allow reselling of your license?
I think you know what to do.

Ummm, years ago I had to buy a whole laptop to get EagleCad v6 with a license.
EagleCad is installed on the hard-disk and node-locked to it

Not a bad laptop in the end, just it's running Window-XP, maybe you can find something similar  :-//


[0] Message Index

[#] Next page

There was an error while thanking
Go to full version