General > Buy/Sell/Wanted

WTB : Tektronix broken TM module (need the metal case)

(1/2) > >>

psykok:
Hi,

I have a TM module without case and I'm looking for a broken one or just for the metal enclose to rebuild mine.


ALex

Stray Electron:
  Not sure which part you need but the plugins for the old Tektronix 5000 series scopes are mostly the same but longer. So many of the small parts will interchange. Walter Shawlee at sphere in Canada had some TM-500 (mechanically) compatible plugins for sale for around $20 a couple of months ago. walter2@sphere.bc.ca

pamphonica:
Which bits do you need?  I can probably find you the top and bottom pieces plus a metal front-plate from a PG506.  Is that what you need?  I dont have any spare side plates.
Maybe you could send me a PM with details, or photos of what you need.
-Jeremy
(UK)

Hydron:
I might have some side panels I can spare, but getting from two people is a bit unwieldy especially post-Brexit from the UK - are there no cheap junk modules on ebay?
I got an AM503 for 30 quid just as covid hit, which is probably one of the more useful modules (was expecting a parts unit, but all it needed was a dry joint to be touched up and then was 100% OK, including early-80s electrolytics and wet-slug/dipped tantalums).

psykok:

--- Quote from: pamphonica on May 18, 2021, 05:00:32 pm ---Which bits do you need?  I can probably find you the top and bottom pieces plus a metal front-plate from a PG506.  Is that what you need?  I dont have any spare side plates.
Maybe you could send me a PM with details, or photos of what you need.
-Jeremy
(UK)

--- End quote ---

I need actually  all the side panels (bottom, up, left and right) and also the rails to hold them.
Basically I have only the front panel and all the board for this double  size module.



Alex

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version