General > General Technical Chat

[YouTube]: American is impressed by sensible British mains plug design

<< < (16/29) > >>

b_force:

--- Quote from: Monkeh on October 22, 2022, 09:34:43 pm ---
--- Quote from: b_force on October 22, 2022, 09:33:24 pm ---
--- Quote from: themadhippy on October 22, 2022, 09:09:58 pm ---Even a table lamp with an es lamp base?

--- End quote ---
What is the question here?

Any lamp fixture has to be grounded (and therefore connected to a ground), any lamp base is either grounded or double insulated?
A regular light bulb doesn't care, a modern LED bulb also doesn't care?

--- End quote ---

It's not very double insulated when you're screwing in the lamp.

--- End quote ---
Yes it is, once it is screwed.

Technically speaking one has to call a capable person (like an electrician or licensed handy man), to replace those.
In practice this obviously never happens, but that doesn't matter from a standards point of view.

For those lamp fittings with just a simple two prong cable with a small bulb, it is impossible to touch or reach the metal threat of the lamp receptacle. 
Which is also a form of double insulation.

But it does raise an interesting question or point about those full E27 bulbs standing lamps
I guess one has to follow the manual, which means disconnecting the lamp, remove the bulb, install new bulb and connect the lamp again.
Otherwise there is risk of being zapped. I have actually never thought (and cared) about it to be very honest.

With fixed lamp fittings, the Life and Neutral have to be connected according standards, so in that case it's never an issue.
The default standard procedure there, is to switch of the breaker/fuse first and than replace the bulb.

b_force:

--- Quote from: TimFox on October 22, 2022, 09:45:49 pm --- thus removing the temptation to pull on the cord.
(Attachment Link)

--- End quote ---
But increasing the temptation for kids to unplug chords  ???
Which creates all kinds of other hazards.

A schuko has a grip on the sides for this btw
(well some do)

Monkeh:

--- Quote from: b_force on October 22, 2022, 09:52:22 pm ---
--- Quote from: Monkeh on October 22, 2022, 09:34:43 pm ---
--- Quote from: b_force on October 22, 2022, 09:33:24 pm ---
--- Quote from: themadhippy on October 22, 2022, 09:09:58 pm ---Even a table lamp with an es lamp base?

--- End quote ---
What is the question here?

Any lamp fixture has to be grounded (and therefore connected to a ground), any lamp base is either grounded or double insulated?
A regular light bulb doesn't care, a modern LED bulb also doesn't care?

--- End quote ---

It's not very double insulated when you're screwing in the lamp.

--- End quote ---
Yes it is, once it is screwed.
--- End quote ---

So "no, it isn't".


--- Quote ---Technically speaking one has to call a capable person (like an electrician or licensed handy man), to replace those.
--- End quote ---

 :-DD

IanB:

--- Quote from: TimFox on October 22, 2022, 09:45:49 pm ---It is a molded 3-prong plug for US 120 V service, at the end of the attached cord for a relatively modern toaster (that has no internet connection).
--- End quote ---

I am surprised it is a three prong plug. Every small kitchen appliance I have encountered so far has only had a two prong plug on it.

Ed.Kloonk:

--- Quote from: Simon on October 22, 2022, 07:38:29 pm ---OK in 1984 I was 1.....

--- End quote ---

The early '80s was the best time to be 1, so I'm told.

Wait. What?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod