General > General Technical Chat

3M breadboards for cheap

<< < (12/15) > >>

rdl:
Check out the SYB board front center. Rails are broken into thirds. Had me really confused for a few minutes first time I used it.

(click for bigger)

tooki:
My Assembly Specialist haul:



1x SS748 (gold)
1x CS253
1x DS293
2x TS273
4x BB309
1x JW01
1x SS252

All told, this would have cost almost $650 from Digi-Key (and that's pretending you could order just one SS748; the actual minimum quantity is 10, which is kinda prohibitive at $262 each!), and it was $168 from AS, including $22 shipping (to USA).

aeberbach:
Well I was looking for 3M breadboards again, always wanted the big one, and found this thread - surprise, I can afford the big one from Assembly Specialist!

It occurs to me looking at the pictures that the Assembly Specialist label looks like an applied stick label on top of the red enamel steel while the 3M branded ones look like they are enamelled on. Anyone peeked under their Assembly Specialist logo?

tooki:
See also: https://www.eevblog.com/forum/buysellwanted/fs-new-breadboards-assembly-specialist/

Not sure what’s been sold or not, but it’d be even cheaper!

seanspotatobusiness:
I've been buying the BusBoard Prototype Systems breadboards from the US. I'm not sure where they're manufactured but the company is Canadian. I saw them recommended on YouTube and I think they're alright. I would try the 3M/Assembly Specialists but it seems getting them to the UK is hassle.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod