General > General Technical Chat
Any Matlab Simulink experts? How to compare fast signals in continuous mode?
(1/1)
Miyuki:
I was trying to do some control loop fun with Matlab Simulink
But when I was trying to build a current mode converter and run it in the continuous mode it just goes crazy. The comparison just happens all over the place. It just does not work for these fast signals.
When I run it as discrete on reasonably short steps it behaves as it should. But it should be a continuous system.
Is there some setting I have to change to work at this time scale?
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod