General > General Technical Chat
Binary (additive) resistor or capacitor box
eti:
Has anyone ever made a resistor or capacitor box (thumb wheel selectable increments) which works like this:
[jumper 0 ohms] [1 ohm] [2 ohm ] [4 ohm] [8 ohm] [16 ohm] [32 ohm] [64 ohm] [128 ohm]
You'd have all those resistance values and switch them in and out of series with the other resistors to additively create any ohmic value from 0 ohms to 255 ohms. To do the same for capacitors, you'd just switch the values in and out of parallel connection with the others.
This is binary of course.
I hardly think this could be a new thing I'd thought of. Ideas?
Ed.Kloonk:
Use a 8 position dip switch.
https://www.ato.com/8-position-dip-switch
The sub 10 ohm setting precision might drive you bonkers.
eti:
--- Quote from: Ed.Kloonk on December 11, 2022, 06:56:02 am ---Use a 8 position dip switch.
https://www.ato.com/8-position-dip-switch
The sub 10 ohm setting precision might drive you bonkers.
--- End quote ---
Hence me saying thumb wheels would be used. Yeah it would be a silly design to use DIP switches.
ledtester:
Teardown of a IET Decade Resistance Box at 3:00:
EEVblog #211 - IET Decade Resistance Substitution Box -- EEVblog
https://youtu.be/37gYHdY0DAM?t=3m
It uses only 5 resistors per decade in a 1-2-2-2-2 pattern. It uses a custom wiper pattern to accomplish this.
I recall there being a project discussed on the forum where a custom pcb was developed for an existing thumbwheel switch and then you could get that pcb manufactured at pcbway/jlc pcb/etc. to create some sort of substitution box -- can't seem to find it at the moment.
Ed.Kloonk:
--- Quote from: ledtester on December 11, 2022, 07:52:38 am ---Teardown of a IET Decade Resistance Box at 3:00:
--- End quote ---
I had forgotten about that. Gee, you're resourceful.
Navigation
[0] Message Index
[#] Next page
Go to full version