EEVblog Electronics Community Forum
General => General Technical Chat => Topic started by: Bubba on October 01, 2017, 09:18:34 pm
-
Just Curious. How many members have ordered from them/Your experience?
Quality, Service, Speed of delivery after order etc..
I know your not supposed to use NTE parts in Design work, Just as substitutes, But I have a few NTE107's leftover I want to play with. They were left over from replacing the front end transistor in a 11m Radio
10 Boards for $2.00 is tempting.
I'm thinking about ordering a batch of generic voltage divider bias circuit boards, and do a bit of experimentation. I figure if I damage a board changing things around I would have plenty of spares....
Since I have a few "Leftovers" I want to try them as a pre amp for receivers, and if I don't like the performance, try a few different transistors...
Since the NTE107 is being used in the 27Mhz band I hope they will work satisfactory on lower HF frequencies, Maybe even add one to a Xtal set.
73
-
A week, and a 100 views....
I guess nobody has any experience with them......
-
If you're talking about JLCPCB, I have tried them. (Or, more accurately, "EasyEDA", which is the same company)
Their boards were fine (2-layer and 4-layer). I'd say that they were a step above Itead and Seed in quality, especially in the silkscreen department.
I have however stopped using them, as they tried some underhanded/stealth marketing here in the forum. I don't want to support that..
I've never ordered parts from them, just PCBs.