General > General Technical Chat
[S] Bus Pirate: does it STAY in "transparent bridge" (UART) mode?
(1/1)
eti:
I have a JYETech "DSO-150" pocket 'scope, and I have compiled a new firmware from https://github.com/michar71/Open-DSO-150 - what I need to know is, if I use my "Bus Pirate" in "transparent bridge" aka UART mode, and setup that mode using "Teraterm" or whatever, will the Bus Pirate STAY in that mode if I then exit "Teraterm" and use it with "Flash Bootloader Demonstrator" as is required by the DSO-150 upgrade process?

Here's the upgrade guide; I just need confirmation that "Bus Pirate" won't exit UART mode unless I send it the reset signal?

https://jyetech.com/wp-content/uploads/2019/01/dso150-shell-how-to-upgrade-firmware.pdf

Thany Manks!  :P



[UPDATE]:

Once "Bus Pirate" is in UART mode, and all bitrates etc set, you just enter "(1)" and it enters transparent UART bridge mode. I have now successfully updated my JYE TECH DSO-150 to the custom firmware (see below) and will test it soon.

Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod