General > General Technical Chat
can low pass filter change signal width?
<< < (3/3)
elcrni:

--- Quote from: fourfathom on April 26, 2021, 12:41:33 am ---Can you bridge R6 (100k) with a 1K or 100 Ohm resistor? 

--- End quote ---

i can try! :-)



--- Quote from: bsfeechannel on April 26, 2021, 03:53:04 pm ---
--- Quote from: elcrni on April 25, 2021, 10:39:00 pm ---Any way to test this capacitor theory without actually removing it?

--- End quote ---

Do you have a scope?

--- End quote ---

Yes, i do.

Thanks,
Alek
elcrni:
ok, i have bridged R6 (100k) with 1k and then with 100Ohm, not a huge difference but pulse width now dips much closer to both 100ms and 200ms although still goes to as high as 130 and 230.
So if i take the average value, its more or less the same, maybe slightly better, it just get much closer to target values than before.

when i connect everything, first 1-2 pulses get to almost exact values, the they get wider... capacitor?

Many thanks,
Alek
bsfeechannel:

--- Quote from: elcrni on April 26, 2021, 06:29:11 pm ---
--- Quote from: bsfeechannel on April 26, 2021, 03:53:04 pm ---Do you have a scope?

--- End quote ---

Yes, i do.

--- End quote ---

Cool. Then, please, poke around with your scope probe along the signal path and post the waveforms so that we can try to figure out what is going on with the circuit.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod