General > General Technical Chat
can low pass filter change signal width?
elcrni:
--- Quote from: fourfathom on April 26, 2021, 12:41:33 am ---Can you bridge R6 (100k) with a 1K or 100 Ohm resistor?
--- End quote ---
i can try! :-)
--- Quote from: bsfeechannel on April 26, 2021, 03:53:04 pm ---
--- Quote from: elcrni on April 25, 2021, 10:39:00 pm ---Any way to test this capacitor theory without actually removing it?
--- End quote ---
Do you have a scope?
--- End quote ---
Yes, i do.
Thanks,
Alek
elcrni:
ok, i have bridged R6 (100k) with 1k and then with 100Ohm, not a huge difference but pulse width now dips much closer to both 100ms and 200ms although still goes to as high as 130 and 230.
So if i take the average value, its more or less the same, maybe slightly better, it just get much closer to target values than before.
when i connect everything, first 1-2 pulses get to almost exact values, the they get wider... capacitor?
Many thanks,
Alek
bsfeechannel:
--- Quote from: elcrni on April 26, 2021, 06:29:11 pm ---
--- Quote from: bsfeechannel on April 26, 2021, 03:53:04 pm ---Do you have a scope?
--- End quote ---
Yes, i do.
--- End quote ---
Cool. Then, please, poke around with your scope probe along the signal path and post the waveforms so that we can try to figure out what is going on with the circuit.
Navigation
[0] Message Index
[*] Previous page
Go to full version