General > General Technical Chat
Class 2 SMPS - Removing the Y capacitor - Good design solution wanted !
<< < (7/8) > >>
smile:
Thanks for all replies.

So this IRM-45-24ST will not leak 80-50V AC on the negative output pin if ungrounded right?
This will be fine then for automation controler.

"in a sense you are dealing with crappy infrastructure in your home/buisness no?"

yes. no proper grounding.

What about main power for servo/stepper motors. I have Meanwell RSP-320-48 6.7A that can't use also.
What to replace it with?

Regarding "medical" gade nonsense with micro amps leakage see this video for RPS 200 I made years ago
https://youtu.be/lea5JhNpddI

Do you really think the neon lamp would light that bright on 150µA leakage current? For the amount of overpiced money they cost, they should leak none.
smile:
Leakage current for HDR-60-24 is not specified in data sheet?
smile:
Paper on Y cap leakage current
http://www.epqu.agh.edu.pl/archives/journal/v15i2/Jha%5B2%5D.pdf

Seems I can remove it since I do not care about EMI nonsense anyway.
coppercone2:
its a bad idea you would be surprised how many things can be effected by bad electronics.
smile:
Well I decided to put a transformer 24v
https://www.tme.eu/lt/details/tmbz63_002m/transformatoriai-su-tvirtini-elementais/indel/tmbz-63-002m-65va/

then this converter to 24v
https://www.aliexpress.com/item/1005004463519267.html

For other more powerful PSU that drives motors these should be no issues as no direct contact betweek GND and ground.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod