General > General Technical Chat
Complete newcomer to PCB layout - where do I start?
(1/10) > >>
eti:
Complete newcomer to PCB layout - where do I start?

Let me say this - the last time I was shown PCB layout, was a cursory overview at college, back in the 90s. I have never done it myself, and would greatly appreciate any help in "noob form" (not "idiot form"  ;D ;D) syntax. If you could point me to a tutorial, that would be superb, since YouTube is an OCEAN of them, and I do not know which is better and which is worse.

Thanks ever so much. :)

Matthew.
MarkF:
I found DipTrace to be the easiest to learn after trying Eagle and KiCad.
The free version is only limited by the number of pins and two layers.

Here is a video on an old version of DipTrace (kind of lame, but all the steps to create a PCB and schematic).
Sorry, I couldn't find a good tutorial.

Note:
You can start doing a PCB layout without a schematic if your circuit is simple enough. 
Just place the components you need onto the board.

nctnico:
Maybe take a step back before even comitting to software. Creating a PCB is solving a 3D puzzle. The first thing to do is to get a idea on how a circuit would best fit on a PCB. What are the constraints (position of connectors, buttons, LEDs, etc)? And how would the components fit on the board the best way to minimize the connections? A good exercise is to start with a piece of paper and a schematic for very simple circuit (something with an NE555 or so to blink a LED) and (re)draw the connections in the schematic in a way the wires don't have to cross.

From there try to use a CAD program to turn the same diagram into a board. I strongly recommend to draw a schematic as well because this will allow the PCB software to verify the connections are according to the schematic. Otherwise you are on your own.
eti:
Two very helpful replies, and much wisdom found in them, especially the latter. Thank you so much.  🙂
rstofer:
I use the ExpressPCB.com service to make my boards and I use their software.  It has no automation whatsoever and it certainly doesn't do autoroute.  Still, I have had great success with the boards I have had them make and I didn't have to spend weeks learning to use software.

Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod