General > General Technical Chat

Cost - 3D printed enclosure vs Project box?

<< < (12/12)

brucehoult:
I don't stop the printing. I just snip the old filament a few cm from the extruder, and get it changed and the new filament butted up against the new one and pressed in by hand before the end of the old filament gets to the knurled feed roller in the extruder. It's not like it moves all that fast. Never had a problem doing it.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod