| General > General Technical Chat |
| Crimp tool for 0.250 Spade terminals |
| (1/2) > >> |
| DeanA:
Can anyone recommend a decent crimp tool for the 0.250, 6.3mm non insulated spade terminals like this preferably available locally in Australia. I found this one at E14 https://au.element14.com/duratool/ht-230c-ht-236c/crimp-tool-inter-lockingnon/dp/3126341 which looks correct from the photo's and the price is good, but not 100% sure if that is suitable for the faston 250 type spade terminals. The manufacturer specific one I found at digikey, 755414-1, is $5000. Or I found "47417 CRIMP TOOL, FASTON 250 SERIES TERMINALS" at E14 but that's $800, both way over my budget. |
| VK3DRB:
Some crimp tools are hideously expensive, eh. Rocky Electronics in Melbourne sells this... https://www.rockby.com.au/catresultsSql_12.cfm?Stock_no=21037 I use one for 6.3mm spade terminals with plastic sleeves, and it works a treat. It might work for your terminal without the sleeve. I have also found good quality crimping tools on eBay (and there is a lot of rubbish there too). Failing that, there are companies in Melbourne who provide a crimping service. They have automated crimping machines. |
| DeanA:
--- Quote from: VK3DRB on December 07, 2021, 11:32:31 am ---Some crimp tools are hideously expensive, eh. Rocky Electronics in Melbourne sells this... https://www.rockby.com.au/catresultsSql_12.cfm?Stock_no=21037 I use one for 6.3mm spade terminals with plastic sleeves, and it works a treat. It might work for your terminal without the sleeve. I have also found good quality crimping tools on eBay (and there is a lot of rubbish there too). Failing that, there are companies in Melbourne who provide a crimping service. They have automated crimping machines. --- End quote --- Thanks, I've got one of those crimpers for the insulated terminals which works great. It's the uninsulated spade terminals I need a crimper for, it should simultaneously crimp to the wire and strain relief to the wire insulation. I'll give that Duratool HT-230C one from Element 14 a go, I just can't find enough information to decide if it's the correct one. These uninsulated spade terminals are very common so I thought there would be a few decent quality crimpers available for them. Regards, Dean. |
| Muttley Snickers:
You could try Rhino Tools, they generally have a good assortment of crimpers and reasonable prices as well. https://rhinotools.com.au |
| WattsThat:
Not a big fan of Amazon but... perhaps this is available in Oz either through Amazon or others: https://www.amazon.com.au/Glarks-Self-Adjusting-Terminals-0-5-1-5mm%C2%B2-Connectors/dp/B07KVFKXS6/ref=sr_1_1 |
| Navigation |
| Message Index |
| Next page |