General > General Technical Chat

DEADLY WIRING FAULT ; Atten 858D+ Hot Air Rework Station

<< < (21/44) > >>

BravoV:
Just downloaded and grabbed the picture in the Hakko 850B manual, the photo below should be self explanatory.

saturation:
Its more versatile than the Hakko manual shows.  You can squeeze or expand the fork to fit different spaced components; you can also use one end at a time; in through hole components you can insert it between leads and twist or lift it up to pull the leads out of the holes while desoldering or using hot air.  I use that tool a lot, before it I used sold wire or paper clips.

zany:
Bought one of these Atten units 2 weeks ago... looks like I'll have to tear it apart!   :)  Will take some pics, hopefully most QA issues have been resolved.

zany:
Apologies in advance for the crappy quality of the photos... really need another camera...

Notes:

- Earth ground is connected to chassis via lower rear right screw, the back plate and body metal have been sanded down to bare metal.
- continuity passed from metal nozzle of handle and bracket metal to earth prong of IEC
- measured 28 Ohms from metal nozzle to earth prong, OL from bracket metal to earth prong

saturation:
Your photos are very blurry, its not the camera is the focusing.  Good luck with the repairs.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod