General > General Technical Chat

DEADLY WIRING FAULT ; Atten 858D+ Hot Air Rework Station

<< < (32/44) > >>

madworm:
We know. And that guy has posted about it on here as well 8)

Make sure to post about your additions as well. Worth a new thread.

engywook:
Hello,

I received an ATTEN 858D+, bought on ebay from Germany.  I plugged it, it heated, but it was not blowing. I opened the gun and measured the voltage at the fan pads, it varies from 11V to 28V when turning the button (looks normal to me). I de-soldered the fan and powered it directly from a 3S lipo battery fully charged (14.4V), but it is not spinning. I tried to reverse the polarity, without success. I can spin the fan manually, it is not blocked at all. It must be the motor, but I can't reach it.

I have already contacted the reseller to mention the defect object, but if any of you has a link to buy a spare fan, I would have a backup plan.

Thanks

PA4TIM:
I really can not understand so many people here are still buying this crappy lethal junk.  |O |O

n45048:
I have a quick question that is slightly off-topic.

My parents home has an RCD built into one of the power points (it has the test/reset buttons directly on the wall socket). Considering that RCDs have been mandatory in Australia since the very early 1990's, what's the point of having one on a single power outlet? (It does share the same circuit as the kitchen outlets and on rare occasions, it has been known to trip when dodgy toasters are plugged in, but everything on the distribution board remains on).

TorqueRanger:
So are these worth buying or is there a same price alternative???
Or am I better off finding a Yihua Setup and rebuilding and  modding it ???

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod