General > General Technical Chat
DEADLY WIRING FAULT ; Atten 858D+ Hot Air Rework Station
<< < (35/44) > >>
electr_peter:
Is there any difference between Atten 858D+/Wep 858D/Youyue 858D/Pro'sKit SS969B? These models seem to be identical except for front panel sticker. Pro'sKit unit might be slightly better.

UPDATE: Pro'sKit SS969B unit is very nice inside - good quality PCB with SMD components, all wire connections have sockets and are glued down with red glue, mains wiring is done properly - no real issues quality wise. And it works.
IanJ:
Mine was intermittetn when I got it........opened it up and the mains wiring was threadbare inside.

Cheap junk right enough........but does work pretty well.

Ian.
toyman:
Bought a "WEP 858D" on ebay, although the unit that I got has no branding - just the 858d part.   Thanks to this thread I tool a look inside, and found that that fuse is on the neutral wire.  That seems to be the worst of it, so it looks like I got a "good" unit compared to what others have encountered.
electrolux:
My brother bought one, it was fine. Some dodgy Chinese worker I expect.
alexanderbrevig:
Mine came with one of the connectors in the breeze (with no connection). It had the wrong (way too large) spade connector so I changed that, and soldered it to place before pulling the shrink tube over it. THOU SHALL NOT COME OFF
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod