General > General Technical Chat

DEADLY WIRING FAULT ; Atten 858D+ Hot Air Rework Station

<< < (20/44) > >>

Monkeh:

--- Quote from: aquaaddict on June 04, 2013, 08:25:06 am ---
--- Quote from: Monkeh on June 04, 2013, 08:10:53 am ---You know you can replace the plug without changing the entire cable.. right?

--- End quote ---

ha ha yes, but Ill just chop the iec plug off a spare iec mains cable and use that so has moulded mains plug on the other end. I work in IT so I always have spare free iec cables around.

--- End quote ---

You trust moulded plugs more than one you've assembled yourself?

And, uh.. I don't know. Hot nozzle stand?

BillyD:

--- Quote from: aquaaddict on June 04, 2013, 08:25:06 am ---Oh and anyone know what this is?


I am sure it is obvious but I cant see it...

Anthony

--- End quote ---

I puzzled over that for a while too and concluded (possibly incorrectly) that you use the screw to assemble it into a springy fork shape, and use it for holding components in place while soldering them.

aquaaddict:
yes some sort of very basic tweezers type arrangment was the only conclusion I reached but it would be so poor I presumed it must have a better use

BravoV:
That is a FP smd pickup wire and the handle, just google for Hakko 850B manual in pdf and see for your self.

Monkeh:
Ahh, so it's what fancy people use instead of flipping the part off the board with a screwdriver. ;)

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod