General > General Technical Chat
decoding Waveform
(1/1)
NHSA:
Hi,

I did not find a place where to post my question and I hope here it is OK.

I have made two small loop antennas for a lightning detecting project based on the Blitzortung hardware.

Now I need to find more or less EMI free a place where to loacte the antennas.

Is there a way to decode the EMI producer by looking at the waveform the oscilloscope delivers ?

For example like the image below

Thanks Rainer

NHSA:
Hi,

Thank You.

This is going to be a fixed setup. I used first the simple method of sniffing EMI using a portable AM radio.

Will keep searching and looking at the waveforms I see and perhaps switch on and off a few things at the place and see how they react.

Rainer
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod