| General > General Technical Chat |
| Determining rotational accuracy of a drive unit. |
| << < (8/8) |
| nctnico:
--- Quote from: Puffie40 on May 21, 2021, 09:26:16 pm --- --- Quote from: nctnico on May 21, 2021, 08:56:17 pm ---It could be the stepper motor has an internal reduction which then adds to the error as well. --- End quote --- No, the stepper motor has no other reduction- it is a direct drive. It's full step size appears to be 1.8 degrees, since its lowest resolution is 200steps/rev. --- End quote --- But that is not what it says in your original post; there you start with a stepper which has 25000 steps/revolution and then goes through a 1:20 reduction. |
| james_s:
--- Quote from: nctnico on May 21, 2021, 11:39:30 pm ---But that is not what it says in your original post; there you start with a stepper which has 25000 steps/revolution and then goes through a 1:20 reduction. --- End quote --- The motor is direct drive with no integral gearbox, it drives a separate mechanism which results in a 1:20 reduction, at least that's how I read it. |
| Navigation |
| Message Index |
| Previous page |