General > General Technical Chat

DSE T2000 T2200 Soldering stations.

(1/4) > >>

PeterG:
Like many Aussies i use a DSE T2000, it has served me well for many years. Does anyone know if this model is a rebadge of another make?
It has been suggested it is some form of Weller? Can anyone confirm this?
I am looking for spare tips for my T2000.

Regards

Psi:
I have a DSE T2250 and AOYUE968 and they both use the same tips, they're a common type but i dont know what the type is called, sorry.

johnwa:
I have a T-2200, I agree that they are quite nice irons, I did have a faulty thermocouple in mine at one stage, but managed to get a replacement element assembly. I share your dilemma regarding the tips, I have been half tempted to get some copper rod and turn up some replacements, I would need to figure out a way of plating them though.

The three tips I have here measure 5.1-5.2mm diameter x 28mm long shank, with a 6.7-6.9mm dia x 4mm long shoulder. There is probably a tip from another brand of soldering iron that would fit, if you can find it.

I have got a rough circuit traced out for these irons somewhere. I could probably upload it if anyone needs to do some repairs.

Psi:
Just remembered that I bought some tips at jaycar that fit my DSE T2250 and AOYUE968 it wasn't labeled for those irons though, from memory it was for a goot iron

They had a 3 sizes i think.


Does anyone know if the T2250 uses the same tips as the T2200 ?



PeterG:
Thanks for the info, i have looked at the t2250 but didnt think much of it at the time. Now it is going so cheep i might see if i can get it past the household finance controller(Wife)..... ;D

Regards

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod