| General > General Technical Chat |
| Electronic Parts Management Software |
| << < (4/5) > >> |
| myval:
Hi msr, I have used BOMIST for few hours now and I might have few suggestions already. Definitely number one is to get rid of manufacturer and manufacturer partnumber as required field, I have been trying to add whole bunch of resistors and SMD caps and inventing PN for each component is serious waste of time. it is fine when you add parts you just purchased and are new in a bag with part number but what you have already in stock might or most like will not have this luxury. Change theme I don't know if it is only me but these gray letters on black are not doing too good to my old eyes. Nice feature would be bulk add that would be a dream. Eg you want to add 50 different resistor values and you be only typing in values how fast would that be (since it is bulk add they are all resistors they all should go in the same location...... Speaking of storage location that should be there when you add part. Adding part -> assign location -> quantity, boom you are done and don't have to jump through few screens to assign location and quantities and ..... Otherwise looks like a tool with a lot of potential. Thanks Josef |
| myval:
and import does not import tolerance and label. I have tried import with manufacturer empty and it did not import but I did not even get any message that it failed or what actually happened. I will be back with more ;) |
| myval:
bit more ^-^ all my imported capacitors are now in Ω, now I have to go through it one by one and change Ω into F oh yeah sort order be nice bit more refined as in 1Ω .... 999Ω, 1k .... 999k separate F and Ω and so on in filters is manufacturer missing (required field and can not filter by it) :-DD that is about it for today I think |
| FlexDex:
I'm currently using MiniMRP (https://www.minimrp.com/), it's also good for assemblies as well |
| SilverSolder:
--- Quote from: SherlockOHMS Ω on October 13, 2019, 08:26:02 pm ---No could not get it up and running. I've since given up Partkeepr has discontinued its upkeep about a year ago. I've played around with PartsBox, but does not satisfy my needs. I am doing my own for now on Access, but not thrilled with that either. Thanks for following up on this. --- End quote --- I use Access for this kind of stuff too, you can customize it 100% to your needs - the only downside is the work involved in doing that... |
| Navigation |
| Message Index |
| Next page |
| Previous page |