General > General Technical Chat
Fluke 87V displaying "Lead" and sounding beeper when nothing is plugged in
king.oslo:
Hello there,
I've got a Fluke 87V.
Today, when I came to switch it on, it began sounding an alarm and display "lead" when I switched it on, despite nothing being plugged into the jacks.
When it turn it to mA or uA, it shuts up.
Is this a common problem? What should I check?
Thank you for your time.
Kind regards,
Marius
NiHaoMike:
Use compressed air to blow out any dust.
king.oslo:
That worked.
Is there optical sensing of the input jack?
Kind regards,
Marius
NiHaoMike:
If you take a look at the teardown of the 28 II, yes, it's optical.
king.oslo:
Thanks!
Kind regards,
Marius
Navigation
[0] Message Index
[#] Next page
Go to full version